Skip to main content
Schneider Electric A9C15183

A9C15183 Acti9 CT Contactor, 2P, 25 A, 230 V AC

MPN A9C15183
Obsolete

Schneider Electric Acti9 CT contactor, A9C15183, 2P, 25 A AC-7A rated operational current, 230 V AC 50 Hz control voltage, clip-on DIN rail mount, IP20.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

A9C15183 key specifications
ParameterValue
Control typeRemote and manual control
Control signal typeMaintained
Main product or component typeContactor
Voltage250 V AC 50 Hz
Coil voltage230 V AC 50 Hz
Insulation voltage ui500 V AC
Current25 A AC-7 A 8.5 A AC-7B
Frequency100 switching operations/day
Poles2P
Utilization categoryAC-1 conforming to IEC 60947-4
Temp storage max60 °C
Temp storage min-40 °C

All specifications

A9C15183 additional specifications
ParameterValue
Temp operating max60 °C
Temp operating min-5 °C
Storage temperature-40...60 °C
Pollution degree2
ColorWhite
Depth66 mm
Width18 mm
Height90 mm
ApplicationControl circuit
Operating temperature-5...60 °C

Product details

Acti9 CT Contactor – A9C15183

It clips onto a 35 mm symmetrical DIN rail and occupies 2 x 9 mm pitches (18 mm wide), so it fits neatly into a compact modular enclosure alongside other Acti9 devices. Rated operational current is 25 A in AC-7A category and 8.5 A in AC-7B — the AC-7A figure governs resistive loads like lighting or heating, while AC-7B covers inductive loads typical of small motors. Control voltage is 230 V AC at 50 Hz, with an inrush of 15 VA and a hold-in draw of 3.8 VA.

For motor loads, the AC-7B rating of 8.5 A is the figure to use — that's the inductive switching capacity. The 230 V AC control coil is standard for European panel builds, and the 50/60 Hz tolerance means it works on both common mains frequencies. Pollution degree 2 is the typical industrial environment where only non-conductive pollution occurs, with occasional condensation.

The 18 mm width (2 x 9 mm pitches) matches the Acti9 modular system, so it aligns with MCBs, RCDs, and other Acti9 devices on the same rail. Power circuit terminals are tunnel type: accept up to 2 x 2.5 mm² flexible or 1 x 6 mm² rigid. Control circuit terminals take 2 x 2.5 mm² flexible or 2 x 1.5 mm² rigid. Wire stripping length is 10 mm, tightening torque 0.8 N·m. The 2 NO pole contact composition gives two normally-open main contacts.

MPN
A9C15183