Skip to main content
Schneider Electric LX4FF375

TeSys LX4FF375 Contactor Coil, 375 V DC, Active

MPN LX4FF375
Active

TeSys range, LX4FF contactor coil, 375 V DC, DC low consumption, without built-in suppressor module.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX4FF375 specifications
ParameterValue
Control circuit typeDC low consumption
Main product or component typeContactor coil
Coil voltage375 V DC
Temp operating max55 °C
Temp operating min-5 °C
Operating time30...40 ms closing 30...50 ms opening
Operating temperature23...131 °F (-5...55 °C)

Product details

The LX4FF375 is a replacement contactor coil from the TeSys range, designed for FF-frame contactors. It operates on a 375 V DC control circuit with low consumption characteristics, meaning it draws minimal holding current once the contactor is sealed — relevant for panels with shared DC supplies where cumulative coil draw matters. Coil resistance measures 249.2 Ω inrush at 20 °C and 52776 Ω holding at 20 °C. The wide ratio between inrush and holding resistance is typical of DC low-consumption designs: high inrush current for fast pick-up, then a much lower holding current to reduce heat and power draw.

Control voltage limits and timing

The coil is rated for an operational voltage range of 0.85 to 1.1 Uc at 55 °C, so it will reliably pick up between about 319 V DC and 412 V DC. Drop-out occurs between 0.15 and 0.2 Uc at 55 °C — roughly 56 to 75 V DC — which means the contactor drops out cleanly on a sagging DC bus without chattering. Closing time is 30 to 40 ms; opening time is 30 to 50 ms. These are consistent with standard TeSys contactor coil performance and allow coordination with upstream protection devices in motor starter applications.

The coil ships without a built-in suppressor module. If your application requires flyback suppression on the DC coil — common when the control circuit includes PLC or solid-state outputs — you will need to add an external diode or varistor across the coil terminals.

MPN
LX4FF375