Skip to main content
Schneider Electric LX4FK033

TeSys LX4FK033 Contactor Coil, 33 V DC, Active

MPN LX4FK033
Active

TeSys LX4FK033, contactor coil, FK series, 33 V DC, DC low consumption, without built-in suppressor module.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX4FK033 specifications
ParameterValue
Control circuit typeDC low consumption
Main product or component typeContactor coil
Coil voltage33 V DC
Temp operating max55 °C
Temp operating min-5 °C
Operating time45...60 ms opening 50...60 ms closing
Operating temperature23...131 °F (-5...55 °C)

Product details

Part Identity and Sourcing Status

The LX4FK033 is a replacement contactor coil from the TeSys range, designed for FK-series contactors. Its control circuit is a 33 V DC low-consumption type, without a built-in suppressor module — meaning you need to add external flyback suppression (a diode or RC snubber) across the coil terminals if driving from a PLC output or solid-state relay that can't handle the inductive kick.

Electrical and Timing Characteristics

Operating time is 45 to 60 ms opening, 50 to 60 ms closing. That's within the typical range for a contactor coil of this size — fast enough for motor starting and general switching, but not a high-speed application. The coil draws a 0.99 Ω inrush at 20 °C, settling to 258 Ω holding at the same temperature; the low holding resistance keeps power dissipation down once the contactor is sealed in. Control voltage limits are specified: dropout occurs between 0.2 and 0.35 Uc at 55 °C (about 6.6 to 11.6 V DC), and operational pickup is guaranteed between 0.85 and 1.1 Uc at the same temperature (28 to 36.3 V DC). If your control supply sags below 28 V DC at the coil terminals, the contactor may not pull in reliably.

This coil mounts directly onto the FK-series contactor's magnet system. It's a service part — you replace the coil, not the whole contactor, which is the typical approach for a Tier-1 automotive line where full part genealogy and zero-defect traceability are required. The coil itself carries no serialized traceability, so ensure your line-side replacement procedure captures the contactor's nameplate data before swapping.

MPN
LX4FK033