Skip to main content
Schneider Electric LX9FJ928

TeSys LX9FJ928 Contactor Coil, 155 V AC / 140-156 V DC

MPN LX9FJ928
Active

Schneider Electric TeSys F series, specific contactor coil LX9FJ928, 155 V AC / 140-156 V DC, 60 ms opening, 20 ms closing.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX9FJ928 specifications
ParameterValue
Control circuit typeAC 40...400 Hz low consumption DC low consumption
Main product or component typeSpecific contactor coil
Coil voltage140...156 V DC 155 V AC 40...400 Hz
Temp operating max55 °C
Temp operating min-5 °C
Mechanical life cycles10 Mcycles
Operating time60 ms opening 20 ms closing
Operating temperature23...131 °F (-5...55 °C)

Product details

The LX9FJ928 is a specific replacement coil for the TeSys F contactor range, designed for environments where ambient temperature stays below 70 °C. It's the part you pull when a contactor coil fails open or shorted, not the whole contactor assembly — keeps the panel rebuild to a single component swap. Control voltage is dual-rated: 155 V AC at 40-400 Hz, or 140 to 156 V DC. That covers both legacy 110 VAC control schemes stepped up through a transformer and 125 VDC battery-backed trip circuits common in utility and industrial switchgear. Opening time is 60 ms, closing time 20 ms. For a coil swap, those numbers matter for coordination with upstream breaker trip curves — the 60 ms opening means the contactor clears before a molded-case breaker's short-time delay expires on a fault.

Installation note — suppressor module required

This coil ships without a built-in suppressor module. On AC control, that means you need to add an external RC snubber or varistor across the coil terminals to prevent back-EMF from welding auxiliary contacts or glitching the PLC output driving it. On DC control, a free-wheeling diode is mandatory — polarity-sensitive, so verify before wiring. Heat dissipation runs 11.4 to 13.9 W. In a densely packed panel, that's enough to raise the internal ambient a few degrees — check the TeSys F thermal derating curve if the enclosure is already near the 55 °C operating limit.

MPN
LX9FJ928