Skip to main content
Schneider Electric ENW13267

Schneider Electric ENW13267 EasyPact NW Switch Disconnector,

MPN ENW13267
Active

Schneider Electric EasyPact NW, switch disconnector, ENW13267, 3 poles, 1000 A AC-23A, 440 V AC, drawout mounting, IP30.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

ENW13267 key specifications
ParameterValue
Main product or component typeSwitch disconnector
Voltage440 V AC 50/60 Hz conforming to IEC 60947-3
Insulation voltage ui1000 V AC 50/60 Hz conforming to IEC 60947-3
CurrentAC-23 A: 1000 A AC 50/60 Hz 440 V
Utilization categoryAC-23 A
IP ratingIP30
Terminal pitch70 mm without spreader
Temp storage max85 °C
Temp storage min-40 °C
Temp operating max70 °C
Temp operating min-5 °C
Storage temperature-40...85 °C

All specifications

ENW13267 additional specifications
ParameterValue
Pollution degreeclass 3
Depth277 mm
Width288 mm
Height322 mm
Mechanical life cycles20000 cycles with maintenance conforming to IEC 60947-3 10000 cycles without maintenance conforming to IEC 60947-3
ApplicationDistribution
Operating temperature-5...70 °C

Product details

The Schneider Electric ENW13267 is a 3-pole switch disconnector from the EasyPact NW range, rated 1000 A in AC-23A utilisation category at 440 V AC. That AC-23A rating means it handles switching of motor loads and other highly inductive circuits — not just resistive — so it's suited for distribution and isolation duty where you need to make and break under load. The drawout mounting lets you rack the unit out for maintenance without disturbing the main bus connections, a common requirement in switchgear lineups.

Withstand and making capacity

Rated short-time withstand current (Icw) is 50 kA for 1 second at 220–440 V, and the rated short-circuit making capacity (Icm) is 75 kA at the same voltage range. These numbers tell you the switch can survive a fault long enough for upstream protection to clear, and can close onto an existing fault without welding contacts. The 12 kV rated impulse withstand voltage (Uimp) confirms insulation coordination for 1000 V systems per IEC 60947-3.

Drawout mounting on a rail base plate. Connection pitch is 70 mm without spreader. Rear connection, vertical or horizontal orientation. The 277 mm depth, 288 mm width, and 322 mm height fit standard switchgear cubicle compartments. IP30 finger protection is adequate for enclosed installation.

MPN
ENW13267