Skip to main content
Schneider Electric MH30702P16A2200

Schneider Electric MH30702P16A2200 Servo Motor, 1380 W

MPN MH30702P16A2200
Obsolete

Schneider Electric MH30702P16A2200 servo motor, MH3 series, 1380 W continuous power, three-phase, IP65, single-turn SinCos Hiperface encoder, without holding brake.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

MH30702P16A2200 specifications
ParameterValue
Encoder typeSingle turn SinCos Hiperface
Shaft end typeParallel key
Main product or component typeServo motor
IP ratingIP65
Length6.06 in (154 mm)
Shaft diameter0.4 in (11 mm)
Centring collar diameter2.4 in (60 mm)

Product details

Motor sizing and drive pairing

The MH30702P16A2200 is a 1380 W continuous-power servo motor from Schneider Electric's MH3 series, designed for three-phase supply. The continuous stall torque is 2.48 N.m across the 115...480 V range, with a peak stall torque of 7.4 N.m — the ratio tells you the short-term overload margin for acceleration and deceleration phases. Nominal torque depends on the drive voltage and type: 2.37 N.m at 115 V three-phase, 2.23 N.m at 230 V single-phase, 2.01 N.m at 400 V three-phase, and 1.89 N.m at 480 V three-phase. The nominal speed follows the same pattern — 1250 rpm at 115 V up to 7000 rpm at 480 V — so the drive voltage selection directly sets the speed-torque envelope.

Environmental sealing and cable routing

IP65 standard means the motor body is sealed against dust ingress and low-pressure water jets — suitable for washdown areas in food processing or dusty packaging lines. The rotatable right-angled connectors let you orient the cable exit in tight cabinets without adding a separate junction box. Maximum radial force at the shaft is derated with speed: 710 N at 1000 rpm down to 390 N at 6000 rpm. This is the bearing load limit — an overhung pulley or belt drive must stay below the curve at the operating speed.

MPN
MH30702P16A2200