Motor cable for Lexium servo drives
This FCE200525B200 is a pre-terminated motor cable assembly for Schneider Electric's Lexium 52 and 62 servo drive families, carrying three-phase power at 840 W continuous and 2000 rpm nominal speed. The cable length is 12.07 in (306.7 mm) — a short pigtail meant for tight panel-to-motor routing where excess cable loop is not an option.
Rated 840 W continuous output power with 4 N.m nominal torque at 2000 rpm — this matches the LXM62 and LXM52 drive ratings at 400 V three-phase input. Peak stall torque hits 18.3 N.m at 1900 mA, enough for high-inertia starts or rapid acceleration cycles on a conveyor or spindle axis. The holding brake (6.75 N.m) locks the shaft when power is removed — critical for vertical-axis loads that must not drift during a power loss or E-stop. Absolute multiturn SinCos Hiperface encoder provides position feedback without a home cycle after power-up — saves time on multi-axis machines where each axis must know its absolute position at boot.
Mounting and integration notes
Flange-mounted motor with 100 mm flange size and smooth shaft (19 mm diameter, 40 mm length) — direct fit to standard Lexium motor brackets. IP69K and IP67 motor protection per IEC 60034-5 means the motor body handles high-pressure washdown (IP69K) and temporary immersion (IP67) — suitable for food-and-bev or washdown zones. Cable terminates with stripped ends — no connector on the motor side; you land the wires directly in the drive or junction box. Confirm the terminal block accepts the stripped wire gauge before committing. Natural convection cooling — no fan, so the motor relies on its own surface area and the machine frame for heat rejection. Derate if mounted in a confined space with restricted airflow.