Motor dimensions and mounting — fits the standard 70 mm flange
The MH30701P01F2200 carries a 70 mm flange (2.8 in) with a 60 mm centring collar and 5.5 mm mounting holes, so it bolts directly to any standard IEC 70 mm motor mount without an adapter plate. Overall body length is 161 mm (6.3 in) with a smooth shaft 11 mm in diameter and 23 mm of usable shaft length — enough to couple to most inline gearboxes or pulleys without shaft modification.
Continuous stall torque is 1.4 N·m (12.4 lbf·in) across the full 115–480 V three-phase range, and the holding brake locks at 3 N·m (26.6 lbf·in) — enough to hold a vertical load without a separate mechanical brake, as long as the load torque stays under that figure. Nominal speed depends on the drive supply: 1250 rpm at 115 V single-phase, 3000 rpm at 230 V, 5500 rpm at 400 V three-phase, and 7000 rpm at 480 V three-phase. The maximum mechanical speed is 8000 rpm, so the motor can overshoot briefly during a fast stop without damaging the rotor. Peak stall torque reaches 4.2 N·m (37.2 lbf·in) at any three-phase voltage — that is 3× the continuous rating, giving headroom for acceleration or short-duration overloads without tripping the drive.
Encoder and feedback — single-turn Hiperface for position loops
The single-turn SinCos Hiperface encoder provides absolute position within one revolution and analogue sine/cosine tracks for high-resolution velocity feedback.
Environmental protection and cooling — IP65 with natural convection
IP65 rating means the motor housing and shaft seal resist dust ingress and low-pressure water jets from any direction — suitable for washdown areas in food processing or for dusty packaging lines. No forced cooling fan means no fan noise and no filter to clean, but the 930 W continuous rating assumes free air around the motor; derating applies if it is boxed in. The rotatable right-angled connectors let the cable exit in any of four directions, so the motor fits tight enclosures without a hard 90° cable bend.
No official successor or cross-reference is listed, so this is the direct replacement for any existing MH3-series installation. The part number is the braked variant (MH30701P01F2200); the non-braked version uses a different order code.