1380 W servo with 5500 rpm nominal speed
The MH30702P06A2200 is a 1380 W three-phase servo motor from the Schneider Electric MH3 series, rated for 5500 rpm nominal speed with a 8000 rpm mechanical maximum. Nominal torque output depends on the drive voltage and phase configuration: 2.37 Nm at 115 V three-phase, 2.23 Nm at 230 V single-phase, 2.01 Nm at 400 V three-phase, and 1.89 Nm at 480 V three-phase — the torque constant is 0.84 Nm/A at 120 °C copper temperature.
Single-turn Hiperface encoder and IP65 sealing
Feedback comes from a single-turn SinCos Hiperface encoder — this is an absolute position sensor that reports the shaft angle within one revolution at power-up, no homing cycle needed on the first move after a power loss. The motor carries an IP65 standard rating, meaning the housing and connector seals protect against dust ingress and low-pressure water jets from any direction — suitable for washdown environments in food processing or packaging lines where hose-down cleaning is routine.
Sizing and mechanical interface
The MH30702P06A2200 uses a 70 mm flange (IEC standard), a smooth shaft with 11 mm diameter and 23 mm engagement length, and a 60 mm centring collar with 2.5 mm depth — the mounting holes are on a 5.5 mm diameter circle. Continuous stall torque is 2.48 Nm across the 115–480 V range at 2.94 A continuous stall current; peak stall torque reaches 7.4 Nm at 9.65 A peak current for acceleration and deceleration transients.