Skip to main content
Schneider Electric SH30701P01A1200

Schneider Electric SH30701P01A1200 Servo Motor, 690 W

MPN SH30701P01A1200
Obsolete

Schneider Electric SH3 series servo motor, SH30701P01A1200, 690 W continuous power, 8000 rpm max mechanical speed, absolute single-turn SinCos Hiperface encoder, IP65/IP67, smooth shaft, without brake.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

SH30701P01A1200 specifications
ParameterValue
Shaft end typeSmooth shaft
Main product or component typeServo motor
Length6.06 in (154 mm)
Shaft diameter0.4 in (11 mm)
Max axial force fa n80 N
Max radial force fr n660 N 1000 rpm 520 N 2000 rpm 460 N 3000 rpm 410 N 4000 rpm 380 N 5000 rpm 360 N 6000 rpm
Centring collar diameter2.4 in (60 mm)

Product details

Power and speed across supply voltages

The SH30701P01A1200 delivers 690 W continuous power from a 70 mm flange frame, but its speed and torque curves shift with the supply voltage. On 400 V three-phase, nominal speed is 6000 rpm with 1.1 Nm torque; on 480 V three-phase, that climbs to 7200 rpm at the same torque. For single-phase 230 V, expect 3000 rpm and 1.4 Nm — the torque stays higher but the speed ceiling drops. Peak stall torque reaches 3.5 Nm across the 115–480 V three-phase range, enough for short acceleration bursts. Continuous stall torque sits at 1.25 Nm, so the motor can hold position at rated current indefinitely without overheating the windings.

Encoder feedback and environmental sealing

The absolute single-turn SinCos Hiperface encoder gives position feedback on power-up without a homing sequence — useful on lines where the machine must resume after a power cycle without re-referencing. The motor body and shaft bushing carry IP65, while the housing meets IP67 per IEC 60034-5, so it handles washdown in food-and-beverage or wet processing areas. No holding brake is fitted on this variant. For vertical-axis loads or applications that must hold position with power off, you will need an external brake or a different motor from the SH3 family with the brake option.

Mechanical limits for belt and pulley loads

Maximum mechanical speed is 8000 rpm — stay below this even if the drive can command higher. The radial force the bearings can handle drops with speed: 660 N at 1000 rpm, down to 360 N at 6000 rpm. If you are driving a belt or pulley, check the radial load at your operating speed against this curve to avoid premature bearing wear. Maximum axial force on the shaft is 80 N. The smooth 11 mm shaft with a 23 mm engagement length accepts a clamp-on coupling; there is no keyway, so torque transmission relies on the clamping force of the coupling hub.

MPN
SH30701P01A1200